Oil and Gas Industries  

ABEL HP Triplex High Pressure pumps - reliability for the Oil & Gas Industry.

To remove the residual moisture in natural gas, ethylene glycol must be injected in the gas drying system at high pressure. This process demands a pump with above-average reliability, long service life, and low residual pulsation. Our international customers who are known to maintain a high level of safety use ABEL triplex high pressure pumps from the HP and HPT series. In addition to quiet operation, this pump has an especially low residual pulsation, which is further reduced by optimally placed pulsation dampeners.
 
PERFORMANCE IS THE KEY TO PUMPING CRUDE OIL. When there is not enough natural pressure from the gas left in the reservoir to pump the oil to the surface, the boreholes are filled with water. This conveys the remaining oil to the surface. ABEL Series HP and HPT pumps are also ideal for this purpose, because they can be used for pressures up to 25.0 MPa (3625 psi).

Conveying oily bilge water is a similar application. ABEL pumps are used to perform this task on a large drilling platform in the Caspian Sea.

Injecting ethylene glycol using ABEL HP pumps.


ABEL diaphragm pumps from the CM, HM and EM series are used to convey abrasive and combustible oil sludge and hydrocarbon mixtures (usually as explosion-proof models). At the largest refinery in Germany, a number of our electromechanical diaphragm pumps have been used successfully for years.